Model Number : NPE03GE-T
Proprietary Passive POE Gigabit Injector (External Type)
 |
PCBA Model : BGJ-1101
Only PCBA Board
 |
Introduction
The Proprietary Passive Gigabit PoE Injector compliant with IEEE 802.3af/at standard. It is suitable for use with products that basically does support Power Over Ethernet. Simply connect the power source to the Adapter, and then use a Gigabit Ethernet cable to connect the Adapter to the device. It is a cost effective solution for deploying Gigabit PoE Wireless Access Points, VOIP Phones, and PoE IP Surveillance environments where the power sources are not readily available.
Highlight Features
- Complying with IEEE 802.3 10Base-T, IEEE 802.3u 100Base-TX and IEEE 802.3ab 1000Base-T
- Supports 10/100/1000M Gigabit Ethernet speed
- Passive PoE (Compatible to 802.3af/at)
- Low cable-loss and remote power feeding up to 100 meters
- Over Current Protection and Short-circuit Protection
- Supports wall mounting and multiple units combination
Hardware Specification
| Product | Proprietary Passive PoE Gigabit Injector |
| Standard | IEEE802.3 10BASE-T
IEEE802.3u 100BASE-TX IEEE802.3ab 1000Base-T Passive PoE (Compatible to 802.3af/at) |
| Network Media | 10BASE –T: UTP Cat. 3 or up
100BASE-TX : UTP Cat. 5 or up 1000BASE-T: UTP Cat. 5 or up |
| Data Transfer Rate | 10/100/1000Mbps (Half-duplex),
20/200/2000Mbps (Full-duplex) |
| PoE Type | Mid-span (Type-B): PIN 4/5,7/8 |
| Power Interface | Input : DC In
Output : RJ45 POE out |
| Power Requirement | External Power Supply |
| Power Supply | Optional |
| LED Definition | System: Power (Green) x1
l Light On: Power on l Light Off: Power off |
| Temperature | Operating : 0° to 55° C
Storage: -40° to 70° C |
| Humidity | 5% to 90% non-condensing |
| Dimension
( W x D x H ) |
NPE03GE-T : 53.96*41*23mm
BGJ-1101 : 35 *35 mm |
| Weight | NPE03GE-T : 30g
BGJ-1101 : 17.6g |
| Case of material | ABS |
| Certifications | TBD |
**Specifications can be negotiated separately according to needs.